|Machine Type:||Circular Round Separator||Motor:||Vertical Vibrating Motor|
|Voltage:||220V And Others||Core Components:||PLC, Engine, Bearing, Motor, Pump|
Carob Vibratory Screening Machine,
Fine Powder Vibratory Screening Machine,
Dust Cleaning Powder Vibrating Screen
The operation steps of vibrating screen are as follows:
1. Check whether the springs and screws are loose before starting the machine; Whether the oil volume between the bearings meets the requirements; Whether the screen body and spring have cracks; Whether the triangular belt is worn or broken; Check whether the screen opening is clean and whether there is broken or blocked. Close the air door of the dust collector before starting the equipment.
2. When interlocking is started, the emergency switch can be closed after receiving the "pre start" signal, and the equipment will start with the system.
3. In case of non interlocking operation, the equipment can be started individually.
4. After the vibrating screen operates normally, open the air door of the fan.
The actual screening process is:
after the crushed materials with different particle sizes and mixed coarse and fine enter the screen surface, the material layer is dispersed due to the vibration of the screen box, and the small particles pass through the gap and transfer to the lower screen surface. Due to the small gap between the small particles, the large particles cannot pass through and will stay on the screen surface, so the originally disorderly particle groups are separated, that is, they are layered according to the particle size to form small particles below, The arrangement rules of coarse particles. The fine particles that reach the screen surface and are smaller than the screen hole are screened through, and the coarse and fine particles are finally separated to complete the screening process.